Started wiring by installing the relay negatives.
Adding few more wires.
All fitted - bit insane at this point.
Relay earth point fitted then wires tied ready to finally secure the relay bases.
Fitted to base.
Fitting the accessory feed relay.
The fuseholders will fit above the relays on a removeable plate. The fuses generally have a common feed on one side, I have used flag crimps soldered on.
Crimps soldered.
Fuseholders fitted in the lid.
Checking the wire length.
Outgoing fuse wiring fitted.
Had to make a jig to hold the components in their final position to make sure everything fits.
Finishing fuse wiring. This must fit when the lid is down.
Like this.
Final tidy up.
next post will be testing then fitting the outer sleeve.
